Subject	Might also want to pull it off and check for rust.
Posted by	Spddracer on October 29, 2004 at 5:25 PM
	This message has been viewed 18 times.
In Reply To	Where and how much for a CamPositionSensor ?? (n/m) posted by BrianTT(TPA,FL) on October 29, 2004 at 05:01 PM
Message	If its rusted on the gear end where it goes into the cam you may need a cam also. They fluctuate when the sensor gets worn on the end of the camshaft drive. This will also wear out the cam where it runs the sensor which is not so good.
Follow Ups	Where and how much for a CamPositionSensor ?? (n/m) - BrianTT(TPA,FL) 17:01:48 10/29/04 Do you mean a crank angle sensor? Try www.CZP.us - YugoBernie (NoVA) 17:04:23 10/29/04 Yes... the circular device on the timing cover >> - BrianTT(TPA,FL) 17:06:21 10/29/04 Have him reverse his probe on the lead wire, before you - YugoBernie (NoVA) 17:11:21 10/29/04 Also have him try a plug-wire between the plug and coilpack. - Snoguitar 17:20:53 10/29/04 agreed. I have good luck on the wire going to the coil pack (n/m) - Guapo 17:26:02 10/29/04 Actually I think Nissan does refer to it as a Cam Angle - dilly yo 18:02:37 10/29/04 2nded. Definitely a Camshaft Angle Sensor on our cars - boileralum 18:15:19 10/29/04 Thats why I pointed it out. Not the norm!! LOL (n/m) - dilly yo 00:47:37 10/30/04 Might also want to pull it off and check for rust. - Spddracer 17:25:10 10/29/04
Post a Followup	You cannot reply to this message because you are not logged in.