Subject	Re: Observed differences between 300degree & SPL solid subframe
Posted by	kuah@splparts.com on October 22, 2004 at 11:17 PM
	This message has been viewed 47 times.
In Reply To	Observed differences between 300degree & SPL solid subframe posted by Z-Jay (Edmonton, AB) on October 22, 2004 at 08:43 PM
Message	Our bottom bushings are designed to use stock brackets, in particular that retains the stock front brackets that tie into the chassis.
Follow Ups	Observed differences between 300degree & SPL solid subframe - Z-Jay (Edmonton, AB) 20:43:59 10/22/04 mine look exactly like the website - ni[X]it 21:16:40 10/22/04 Re: mine look exactly like the website - ni[X]it 21:26:04 10/22/04 nice rusty bolt head on the hicas eliminator. (n/m) - AzHeat 22:10:26 10/22/04 Thanks for checking for me. BTW, when you reinstalled your - Z-Jay (Edmonton, AB) 23:03:24 10/22/04 Reusing the old ones is fine>> - Dallas DamonZ 02:23:18 10/23/04 mine are the same ... the 300degree are flat (n/m) - Guapo 22:17:49 10/22/04 Re: Observed differences between 300degree & SPL solid subframe - kuah@splparts.com 23:17:07 10/22/04 Hmm.. interesting. What are the implications of not being - Z-Jay (Edmonton, AB) 00:45:30 10/23/04 Works fine on ours as well. (n/m) - Dallas DamonZ 02:20:47 10/23/04 So there's no issue with not using the brackets? (n/m) - Z-Jay (Edmonton, AB) 12:14:11 10/23/04 Why would you not use the brackets? - Dallas DamonZ 15:05:29 10/23/04 8 of the same is correct. (n/m) - Dallas DamonZ 02:21:31 10/23/04
Post a Followup	You cannot reply to this message because you are not logged in.