Subject	technically this is technical
Posted by	robo (sebring1970) on October 14, 2004 at 5:19 PM
	This message has been viewed 17 times.
In Reply To	Strut Bar Question... posted by will_k on October 14, 2004 at 05:13 PM
Message	Get a Carbing and Dremel a slot for the strut bar. You still have two bolts holding each half of the throttle cover snug, and I think it looks very cool when done properly. I'm sure someone has a pic of what I'm talkin' about.
Follow Ups	Strut Bar Question... - will_k 17:13:24 10/14/04 technically this is technical - robo (sebring1970) 17:19:58 10/14/04 yes, you can buy a strut tower brace that doesn't require - titivillus37 17:20:48 10/14/04 check out amzperformance.com - drivebyz300 17:33:15 10/14/04 I bought my front strut bar from Stillen. - Riddick 17:35:32 10/14/04 Carbing - FairladyBlueZ 18:35:24 10/14/04 Carbing barely touches the letters on the TB cable cover - max865 19:51:43 10/14/04 Or you can get the Carbon Fiber one from CPARK that is made - SaVageZ™ 20:54:54 10/14/04 i would save that money and buy something else (n/m) - max865 21:56:28 10/14/04 depends... i had to cut a huge piece out of the cover... - Bernie (OOParts International) 09:34:45 10/15/04 This one does! - NATHAN91'TT 19:03:31 10/14/04 Ya, and although strut bars are made for functionality - SaVageZ™ 20:55:36 10/14/04 You are the only person to ever say that! - NATHAN91'TT 16:27:12 10/15/04 May help, was running this one before installing Carbing F&R - Mighty-Znoobie 21:51:52 10/14/04
Post a Followup	You cannot reply to this message because you are not logged in.