Subject	Your Brake squeal can be taken care of
Posted by	JokerF15 (NyxMotorsports) on October 14, 2004 at 12:35 PM
	This message has been viewed 53 times.
In Reply To	Re: Cross drill rotor question posted by BoostLesZ on October 14, 2004 at 12:27 PM
Message	by either purchasing and installing the Nissan Brake Shim Kit or by using 'disk brake quiet' commonly found in most Automotive stores on the back side of the pads. As far as upgrades go, if you are purchasing new rotors, I'd get Slotted just for 'looks', I highly doubt they'll make a difference in everyday driving, but plan on doing full upgrades: 1) Good Street Pads 2) New/Re-Cut Rotors 3) Stainless Steel lines (Important) 4) 300degree Master Brake Cylinder 5) Good quality brake fluid, personally I like the 'Super Blue Racing' Fluid, however there are plenty of good brands. Good Luck -JokerF15
Follow Ups	Cross drill rotor question - ZXRider 12:24:04 10/14/04 Re: Cross drill rotor question - BoostLesZ 12:27:10 10/14/04 Thanks (n/m) - ZXRider 12:29:44 10/14/04 Re: Re: Cross drill rotor question - Kenny 12:32:42 10/14/04 Re: Re: Re: Cross drill rotor question - BoostLesZ 12:38:57 10/14/04 Where can you get Brembo rotors for $25? (n/m) - Kenny 12:48:51 10/14/04 Re: Where can you get Brembo rotors for $25? - BoostLesZ 12:54:42 10/14/04 That's a good price. - Kenny 13:01:24 10/14/04 So, are these comparable to replacement stock rotors? (n/m) - lojaqer 13:04:28 10/14/04 pretty sure they are direct replacement (n/m) - mousersix (San Antonio) 14:46:13 10/14/04 Your Brake squeal can be taken care of - JokerF15 (NyxMotorsports) 12:35:50 10/14/04 Don't get cross-drilled rotors. (n/m) - Kenny 12:29:40 10/14/04 Why? YOU have cross-drilled, don't you? (n/m) - Z-Jay (Edmonton, AB) 14:20:04 10/14/04 crossdrilled helped my fade ALOT. When I had my stockers - shawn300zTT 14:39:22 10/14/04 after some serious power upgrades - I cracked my - Slowninja(Sport600 Inconel Z) 20:19:01 10/14/04 power upgrades wont crack rotors (n/m) - Chris(NJ) 21:54:07 10/14/04 Yes I do. Not needed for street, and cost more ;). - Kenny 15:34:07 10/14/04 Is it just FRONT x-drilled that are known to crack? I was - Z-Jay (Edmonton, AB) 15:36:43 10/14/04 I believe nixit managed to crack all four of his. (n/m) - Kenny 15:42:24 10/14/04 Just get slotted Brembos (n/m) - bassplayr 15:43:27 10/14/04
Post a Followup	You cannot reply to this message because you are not logged in.