TwinTurbo.NET: Nissan 300ZX forum - They don't offer any other offsets for the 10" wheels?
People Seeking Info
 
   


     
Subject They don't offer any other offsets for the 10" wheels?
     
Posted by Zster (Big Red) on October 13, 2004 at 1:29 PM
  This message has been viewed 76 times.
     
In Reply To badass wheel, Gramlight 57pro, will they fit? posted by thrashchild1 on October 13, 2004 at 12:45 PM
     
Message You would be in the ballpark to run a 10 rear with a +45 offset.

Since they don't have it, I'd do a 9 or 9.5" rear with a +38 or +40 offset, either is fine.

For the front, you could do 9" again with the same offset, but most people who buy these wheels are for looks so they like staggered setups.

If you use an 8" in the front, I would use a lower offset, like the +38, you could probably get away with a low +30ish offset and have your wheels closer to being flush with your front fender.

Good luck.

Cheers,

Salah
Aztec Red 300ZX Twin Turbo

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.