Subject	Yeah, theyre not for a Z...
Posted by	WhiteOutZ on October 08, 2004 at 1:54 PM
	This message has been viewed 46 times.
In Reply To	570cc injectors? (n/m) posted by AntiHero on October 08, 2004 at 12:38 PM
Message	I had to use custom fuel rails and totally modified 95+ connectors. As well as solder 10ohm resistors inline. I believe they are made by Sard.
Follow Ups	19-20psi on 93 octane? I can't decide if I should or not... - WhiteOutZ 11:51:04 10/08/04 no problem (n/m) - PunkZTT(Phoenix) 12:07:43 10/08/04 what happened when you dynoed? - nixit 12:15:20 10/08/04 hi nick! (n/m) - Guapo 12:17:51 10/08/04 Re: hi nick! - nixit 12:22:27 10/08/04 i was wondering why you haven't posted in a while (n/m) - BoostLesZ 12:26:30 10/08/04 good to see you back. - trackstar 13:11:02 10/08/04 Re: hi nick! (n/m) - Halo Z 14:26:01 10/08/04 Im going to dyno next week. I have some free runs lined up. - WhiteOutZ 13:56:59 10/08/04 still don't know why i come here anymore. - nixit 14:08:36 10/08/04 Nixit, you should run circles around ASH with a - AzHeat 15:02:42 10/08/04 Negative. I conceed to Ash. - nixit 16:34:31 10/08/04 It all depends on your tune, but I wouldn't... - Scotts94z32 12:27:41 10/08/04 570cc injectors? (n/m) - AntiHero 12:38:46 10/08/04 port and polish :-p (n/m) - craziestbob 12:44:33 10/08/04 Yeah, theyre not for a Z... - WhiteOutZ 13:54:27 10/08/04 I would not. - Chip(GMS Racing) 16:43:55 10/08/04
Post a Followup	You cannot reply to this message because you are not logged in.