Subject	fine tooth hacksaw works ok.
Posted by	E_swift on October 05, 2004 at 11:29 AM
	This message has been viewed 53 times.
In Reply To	How many have you cut using a Hacksaw? I had better posted by AzHeat on October 05, 2004 at 11:08 AM
Message	I usually use a 3phase bandsaw though, it's a bit more rapid. I am sure dremel works too, but for anything larger than AN8, it might be hard to get a straight cut all the way around.
Follow Ups	Steel braided Fuel lines - Zton 00:44:18 10/05/04 What's your reasoning for needing SS fuel lines?? (n/m) - Snoguitar 01:17:21 10/05/04 Re: What's your reasoning for needing SS fuel lines?? - Zton 01:42:09 10/05/04 Heh, bling bling. (n/m) - Snoguitar 01:54:01 10/05/04 they are nice in that retention is decoupled from sealing, - E_swift 02:03:15 10/05/04 ehh it's always good to replace old hoses. - Halo Z 05:27:28 10/05/04 Nothing wrong with new OEM hoses. Last for a good 15 years. (n/m) - Snoguitar 13:42:42 10/05/04 nope, but SS can't hurt. (n/m) - Halo Z 16:54:08 10/05/04 Re: Steel braided Fuel lines - E_swift 02:00:28 10/05/04 Re: Re: Steel braided Fuel lines - Zton 02:05:05 10/05/04 How many have you cut using a Hacksaw? I had better - AzHeat 11:08:14 10/05/04 fine tooth hacksaw works ok. - E_swift 11:29:27 10/05/04 I used find tooth hacksaw and it frayed the braid . - AzHeat 11:37:57 10/05/04 good find, thanks! (n/m) - mousersix (San Antonio) 02:09:21 10/05/04
Post a Followup	You cannot reply to this message because you are not logged in.