Subject	Thanks for the info. I have not taken a compressor housing
Posted by	Chip(GMS Racing) on September 10, 2004 at 12:13 PM
	This message has been viewed 25 times.
In Reply To	PE turbos do not have any coatings on the compressor housing (n/m) posted by aliaZ (broken in) on September 10, 2004 at 10:32 AM
Message	off before.
Follow Ups	Not 2 bash Z1 Motorsports or anything But>>> - Turk (Dallas) 01:20:25 09/10/04 I don't believe em eather, its just marketing tool (n/m) - HakenTT 01:23:04 09/10/04 I would like to know what compressor clearance - AzHeat 01:55:10 09/10/04 If you decrese the clearance on the compressor side - aggiez32 08:49:10 09/10/04 That IHI turbos, Apex uses IHI turbos, as does PE. - Chip(GMS Racing) 09:11:10 09/10/04 PE turbos do not have any coatings on the compressor housing (n/m) - aliaZ (broken in) 10:32:30 09/10/04 Thanks for the info. I have not taken a compressor housing - Chip(GMS Racing) 12:13:22 09/10/04 just have your machinist step the compressor/outlet side. (n/m) - ni[X]it 09:22:03 09/10/04 they own a dyno, so I would assume they compared #'s (n/m) - NSANY(ATL) 08:37:11 09/10/04 Yep, that's an assumption. (n/m) - SeedyROM 10:10:26 09/10/04 the problem is, they have repeatedly shown - ni[X]it 10:22:20 09/10/04 better comparison would be compressor maps. - Dallas DamonZ 10:35:16 09/10/04 I saw a car gain 30 hp on the dynojet with the use - AzHeat 11:50:35 09/10/04 I trust dyno charts that are not from the vendors them - AzHeat 12:04:12 09/10/04 email member you loze about his z1 stage 3s. (n/m) - Chris(NJ) 10:34:06 09/10/04 2nd!! - Spee 22:32:56 09/10/04 Sure they do. If rusell says so it must be true. - Spongerider :) 11:07:23 09/10/04 Ha! That made me laugh... Thanks Sponge... (n/m) - KaZ (VaBch) 13:17:30 09/10/04 What were you doing in OC a little while back? (n/m) - Spongerider :) 13:37:49 09/10/04
Post a Followup	You cannot reply to this message because you are not logged in.