Subject	HI!
Posted by	ENVYMYZ on August 31, 2004 at 11:37 PM
	This message has been viewed 40 times.
In Reply To	Did I make that too hard for you too understand? posted by Spee on August 31, 2004 at 05:23 PM
Message	You replied to this post about Z1, therefore you were talking about this situation. When Z1 puts you through some shit (i.e. not sending your parts, blowing up your lawnmower engine, etc. etc. etc.) THEN you can make valid put downs and general accusations about them, but until then all your doing is blowing hot air, along with a few other Z1 bashers on here. I personally have not dealt with them, which is why I keep my mouth shut on the subject, if you LIKE looking like a retard, then carry on. As for my sn, I dont see how its anymore ridiculous (not rediculous, try spell check next time) than yours. Carry on! Do what you feel is right, because at the end of the day nobody gives a shit.
Follow Ups	Engine is toasted and I'm at fault?!? ver long - red zya in ct *sport'n 600's* 17:34:38 08/30/04 Yikes, Rob.. that sucks big time. Hopefully you can 'work - Scotts94z32 17:42:28 08/30/04 heh well you wouldn't be the first to have a problem with Z1 (n/m) - spyhunter(nj) 17:44:01 08/30/04 And you wouldn't be the first to make a claim without any - aZiator 17:52:57 08/30/04 sorry, i've just seen a lot of negative posts regarding Z1 - spyhunter(nj) 18:37:44 08/30/04 Well, I am sorry if I was rude then. didn't mean to jump - aZiator 19:13:57 08/30/04 no reasoning to back it up??? - Spee 18:52:32 08/30/04 " (n/m) - Chris(NJ) 18:53:46 08/30/04 I will agree that Z1 had its share of problems with builds - aZiator 19:11:07 08/30/04 "' - ni[X]it 19:26:09 08/30/04 yup, but everyone will enjoy the bandwagon.. (n/m) - speedr300z (ATL) 19:39:48 08/30/04 agreed. (n/m) - Spee 22:02:29 08/30/04 Umm...? - ENVYMYZ 00:21:33 08/31/04 Did I make that too hard for you too understand? - Spee 17:23:32 08/31/04 HI! - ENVYMYZ 23:37:13 08/31/04 You're not helping your case with them. Really, I thought - Moxie 17:45:07 08/30/04 the guy's depressed and running out of ideas... - ZEngineer (TT) 17:48:35 08/30/04 I am not slamming him, I feel for the guy - Moxie 17:55:14 08/30/04 Re: I am not slamming him, I feel for the guy - Grateful Zed 18:04:19 08/30/04 :/ - zboost 17:51:13 08/30/04 z1 has never had a motor fail. it's all on you.... (n/m) - Halo Z 17:53:24 08/30/04 Re: z1 has never had a motor fail. it's all on you.... - silver z 18:00:11 08/30/04 Good point, I have heard of all sorts of parts failing after - aZiator 18:03:59 08/30/04 i know you are pro Z1 chris. - Halo Z 18:09:33 08/30/04 I hear you, Just trying to mitigate a little - aZiator 18:22:46 08/30/04 If it were me I would call Z1, and keep this between you and - aZiator 18:00:50 08/30/04 BIG second. (n/m) - spotz 18:21:24 08/30/04 Allright this is ludicrous. - Russell@Z1 18:04:51 08/30/04 Wait, he installed the motor? - SeedyROM 18:28:15 08/30/04 Z1 did not install the motor. - Russell@Z1 18:44:04 08/30/04 Yeah, just went through the old posts - SeedyROM 18:49:54 08/30/04 wish them luck BOO! I just lost $7500 & now I have no motor (n/m) - red zya in ct *sport'n 600's* 19:34:54 08/30/04 I wished you both luck - SeedyROM 19:44:21 08/30/04 Dude, there is 2 sides to every story (n/m) - kryptonite729 19:54:42 08/30/04 posting this here is not a bad thing... - 1hotzx 18:33:12 08/30/04 You have a point - SeedyROM 18:42:26 08/30/04 exactly correct (n/m) - red zya in ct *sport'n 600's* 19:18:32 08/30/04 "some are flaming, yes...they are turds with legs" haha - EricTTZ 19:35:38 08/30/04 So you wouldn't call the vendor before posting? - dpjax 19:50:34 08/30/04 Well I decided to go ahead and get the pics - Russell@Z1 18:42:03 08/30/04 Russel I will call you tomorrow around 4pm... - red zya in ct *sport'n 600's* 19:32:35 08/30/04 Russel can you explain the reason for the 3 turbo failure?? (n/m) - red zya in ct *sport'n 600's* 19:04:27 08/30/04 Who installed the turbos?? Who broke in the turbos? (n/m) - speedr300z (ATL) 19:10:21 08/30/04 turbos do not need to be broken in. (n/m) - Chris(NJ) 19:11:49 08/30/04 How about oil at startup? Not needed either?? (n/m) - speedr300z (ATL) 19:18:17 08/30/04 delete your old post b/c i'm right? - Chris(NJ) 19:19:56 08/30/04 No, Just keep telling myself that its not worth my time - speedr300z (ATL) 19:34:45 08/30/04 wonderful response. typical z1 fashion. (n/m) - Chris(NJ) 19:43:13 08/30/04 oh, and prove me wrong. (n/m) - Chris(NJ) 20:05:06 08/30/04 If you want to install a turbo and NOT ensure it is primed - speedr300z (ATL) 20:33:44 08/30/04 i seriously doubt that is what you meant by break in (n/m) - Chris(NJ) 20:47:18 08/30/04 sorry to step in here, but i think it's important, .>>>> - ni[X]it 21:35:38 08/30/04 and FWIW, ..>>> - ni[X]it 21:56:50 08/30/04 ok, thanks... I am not aware of any of the new Z1 turbos - speedr300z (ATL) 22:47:05 08/30/04 hi Bob! - ni[X]it 07:51:15 08/31/04 Hi Nixit, I'll agree with you on most of that... - speedr300z (ATL) 08:31:34 08/31/04 Believe me, much better than the one I originally typed.. - speedr300z (ATL) 20:45:22 08/30/04 when you ask a dumb question its a free for all. (n/m) - Chris(NJ) 20:49:48 08/30/04 So what was the dumb question? Him asking Russell why 3 of - speedr300z (ATL) 20:56:50 08/30/04 your question was the dumb one. (n/m) - Chris(NJ) 08:06:40 08/31/04 once again, a waste... (n/m) - speedr300z (ATL) 09:19:38 08/31/04 I installed the turbo with all new lines and gaskets (n/m) - red zya in ct *sport'n 600's* 19:17:25 08/30/04 Wow, that sucks!...hope that you and Z1 find a way to work - TheTwinZ (Peru) 18:13:21 08/30/04 "JWT aren't the most reliable turbo's"...good one. - SeedyROM 18:25:42 08/30/04 He's just venting so take it easy. You have vented in the - Spongerider :) 18:40:02 08/30/04 True, true - SeedyROM 18:46:25 08/30/04 Really big 2nd.. (n/m) - speedr300z (ATL) 19:21:14 08/30/04 You are going to force them to stop dealing with you... - dpjax 18:43:17 08/30/04 Re: You are going to force them to stop dealing with you... - Magnum 18:53:14 08/30/04 I wish you the best of luck w/ the motor/car, other - Chris(NJ) 18:45:47 08/30/04 can't say that I'm surprised at all. - Spee 18:50:17 08/30/04 Consistant? Consistant with selling engines to people - aZiator 19:03:03 08/30/04 You need a newer Sig. - Spongerider :) 19:07:13 08/30/04 hehe...soon enough, buddy. - Spee 21:58:52 08/30/04 Spee...if you're serious, you're an idiot - dpjax 19:56:02 08/30/04 hi - ni[X]it 19:01:24 08/30/04 Z1 assambled the water pump not me Thanks Nixit - red zya in ct *sport'n 600's* 19:11:24 08/30/04 well,either way, you should have kept all this off the forum - ni[X]it 19:25:18 08/30/04 ding! ding! ding! (n/m) - dpjax 19:53:52 08/30/04 even though Nixit can be a complete asshole... - Jason300zxTT(NoVA) 19:31:10 08/30/04 w00t w00t Jason is agreeing with Nixit. Is the world ending? (n/m) - kryptonite729 19:47:10 08/30/04 Re: even though Nixit can be a complete asshole... - ni[X]it 21:46:51 08/30/04 agreed. Z1 doesn't appear to be at fault to me (n/m) - aliaZ (broken in) 08:02:57 08/31/04 This post is more that I'm looking for advice - red zya in ct *sport'n 600's* 19:01:29 08/30/04 any aftermarket temp gauges? (n/m) - Chris(NJ) 19:02:54 08/30/04 Yes told Z1 that it was normal - red zya in ct *sport'n 600's* 19:09:01 08/30/04
Post a Followup	You cannot reply to this message because you are not logged in.