Subject	Put a screw driver on the end of the hose, pry it to break
Posted by	PLEAZURE in CA (SD) on August 24, 2004 at 12:51 PM
	This message has been viewed 15 times.
In Reply To	Cant pull wastgate vacuum hose lose!! posted by joshsworld21 on August 24, 2004 at 11:47 AM
Message	the seal .. then you can pull it easy.. As long as you didn't lossen it up, you can even ask our governer to pull the hose with you .. you will never get it off in one piece. PLEAZURE in SD The trouble with doing something right the first time is that nobody appreciates how difficult it was. SAVE OUR DEMOCRACY, SAVE OUR ENVIROMENT, PLANT A BUSH IN TEXAS Matt 91TT Aztec Red stg IV+
Follow Ups	Cant pull wastgate vacuum hose lose!! - joshsworld21 11:47:01 08/24/04 i just installed my boost controller yesterday and had.. - BIGJD 11:51:17 08/24/04 I may just have to do that... - joshsworld21 11:53:30 08/24/04 i dont think any lubricant would be able to get in there.. - BIGJD 12:04:14 08/24/04 WD-40 works wonders... mine were a pain too. - PiotrC70 12:29:35 08/24/04 becareful not to pull the hose off the wastegate (n/m) - odium69 12:05:36 08/24/04 Cut the tube off but in an upward motion as to not - Milo (Sport Z Magazine) 12:50:07 08/24/04 Put a screw driver on the end of the hose, pry it to break - PLEAZURE in CA (SD) 12:51:51 08/24/04 45 degree pliers... - MyZ8u 19:33:35 08/24/04
Post a Followup	You cannot reply to this message because you are not logged in.