Subject	I removed mine along with the Nissan lettering.
Posted by	Milo (Sport Z Magazine) on August 23, 2004 at 3:45 PM
	This message has been viewed 20 times.
In Reply To	Painting the throttle cable cover posted by Atl300zxTT on August 23, 2004 at 02:51 PM
Message	It's a fiberglass piece. I sanded the lettering off. Then I used a heatgun and carefully just removed the piece with a putt knife. After that I just sanded the valley by hand and it was all good.
Follow Ups	Painting the throttle cable cover - Atl300zxTT 14:51:07 08/23/04 Either, or. Removing it will likely destroy it and Nissan - YugoBernie (NoVA) 14:53:33 08/23/04 I am purchasing a piece from CPark regardless, i like the - Atl300zxTT 14:56:45 08/23/04 That's really something you have to decide. (n/m) - YugoBernie (NoVA) 16:06:55 08/23/04 Tape it off with painters tape... - Fuzznutz 14:54:21 08/23/04 wanna paint it red, so i thought getting a cpark would - Atl300zxTT 14:57:35 08/23/04 Here's a pic of mine. - Moxie 15:52:46 08/23/04 Just keep it on and either cover it up to keep it factory, - Moxie 14:54:24 08/23/04 Sounds easiest. Look good covered up? wont be too tall? (n/m) - Atl300zxTT 14:58:31 08/23/04 I'd remove the old one first - CarbonZTT 15:14:29 08/23/04 Leave the old one on. - Woody75 (Denver) 15:40:58 08/23/04 ok well then disregard what i said;) (n/m) - CarbonZTT 16:24:39 08/23/04 (carefully) tape over it, then go ahead and paint. - Scotts94z32 14:55:54 08/23/04 I removed mine along with the Nissan lettering. - Milo (Sport Z Magazine) 15:45:15 08/23/04 I put masking tape on it, and gave it to the body shop - PLEAZURE in CA (SD) 16:02:01 08/23/04
Post a Followup	You cannot reply to this message because you are not logged in.