Subject	hmmm.. i'll try that. there's 2 grooves on the top of the
Posted by	takirb on August 23, 2004 at 10:06 AM
	This message has been viewed 26 times.
In Reply To	On some Hondas, the rear caliber is actually threaded posted by boileralum on August 23, 2004 at 08:23 AM
Message	piston that i couldn't get to line back up when i tried putting the old pads back on. after i removed the caliper, i did notice that i could twist it, but i didn't think to twist it back in like a bolt. we haven't ordered the other caliper yet ($60 w/core) so i'll try that before ordering. hopefully i haven't damaged anything else in the process by using a hammer... btw- awesome sig!
Follow Ups	NZR- Brake advice needed... Caliper piston seized? - takirb 07:59:04 08/23/04 Saturn? www.saturnforums.com? - nixit 08:06:41 08/23/04 it's only got one piston, the other side is solid... - takirb 08:10:08 08/23/04 ok, that's a floating caliper then. - nixit 08:22:51 08/23/04 is this the same procedure i'd do to rebuild my Z calipers - takirb 10:08:51 08/23/04 On some Hondas, the rear caliber is actually threaded - boileralum 08:23:03 08/23/04 *caliper (n/m) - boileralum 08:32:03 08/23/04 3rd max with rear disc is that way (n/m) - spyhunter(nj) 08:42:17 08/23/04 err 3rd gen maxima (n/m) - spyhunter(nj) 09:26:04 08/23/04 Took a second but I figured it out :) (n/m) - BigTDogg (MA) 12:58:40 08/23/04 Yup, my old RX-7 was like that. Droe me nuts till I figured> - my91z 09:26:40 08/23/04 yep (n/m) - aliaZ (it finally runs) 09:42:40 08/23/04 hmmm.. i'll try that. there's 2 grooves on the top of the - takirb 10:06:42 08/23/04
Post a Followup	You cannot reply to this message because you are not logged in.