Subject	Never done it myself, but..
Posted by	AaronJB on August 22, 2004 at 5:40 PM
	This message has been viewed 31 times.
In Reply To	Questions about sandblasting/powder coating my plenum posted by Nadir(Detroit) on August 22, 2004 at 05:04 PM
Message	I'd agree that masking tape is just going to get eaten by the blasting.. Perhaps make up some plywood/MDF/sheet aluminum blanking plates and bolt those on prior to blasting? Az
Follow Ups	Questions about sandblasting/powder coating my plenum - Nadir(Detroit) 17:04:59 08/22/04 Seems to me sandblasting would destroy anything you tried - Mountaineer2014 17:27:19 08/22/04 Nadir, who are you getting to Powdercoat, I need some work.. - Gold Z 17:29:17 08/22/04 Re: Nadir, who are you getting to Powdercoat, I need some work.. - Nadir(Detroit) 17:45:58 08/22/04 Never done it myself, but.. - AaronJB 17:40:16 08/22/04 From personal experience - kryptonite729 18:13:47 08/22/04 Re: Questions about sandblasting/powder coating my plenum - 280Zone 19:19:46 08/22/04 Re: Re: Questions about sandblasting/powder coating my plenum (n/m) - 280Zone 19:21:48 08/22/04 Don't they use duct tape? - SactoTodd 19:21:27 08/22/04 I believe ... - MatD 19:46:09 08/22/04 We used to use a sheet of sticky vinyl in my old HS shop.. - Tibby 20:28:01 08/22/04 I used SpeedyZX tape on my calipers when I sandblasted - BigTDogg (MA) 21:40:25 08/22/04 One word....PROTECT these areas. (n/m) - Oppaman Z 22:01:19 08/22/04 tape it off... - dpjax 22:26:02 08/22/04
Post a Followup	You cannot reply to this message because you are not logged in.