| I'm going to have my intake plenum sandblasted tomorrow, and was wondering if the areas where the throttle bodies meet, and where the air balance tube meet can be sandblasted, and if not, what should I use to protect those areas (couple layers of masking tape?) The areas i'm talking about are the bare areas on the plenum in these pics: 
Also, what would I put over those areas to protect it before it is powdercoated? Once again layer it with masking tape? Thanks
Nadir
BEST MOTTO TO REPLACE "IT’S A GREAT TIME IN DETROIT"
"Detroit: Where the roads give massages and the hookers are cheap."
"Detroit: At least the suburbs are nice."
"There’s mo’ to do in Motown."
"Detroit: The realest place on the planet."
"Detroit – we’re workin’ on it!"
"You can see Canada from here."
"Detroit – it doesn’t suck so bad."
"It’s not pretty, but it’s fun." 
I so nailed Amir! - SeedyROM 04/01/03 12:36:48
Fvcker! - KILLR300ZX 04/01/03 16:13:53 Conversation with ZEngineer: George says:
Canada sucks
George says:
you can quote me
|
Questions about sandblasting/powder coating my plenum - 
