Subject	What was the piston to cylinder wall clearance? (n/m)
Posted by	kryptonite729 on August 15, 2004 at 11:25 PM
	This message has been viewed 33 times.
In Reply To	Re: Did whomever install them properly? posted by TwinT's on August 15, 2004 at 11:23 PM
Message
Follow Ups	Piston Question..Any 1 with the "New Weisco" pistons still.. - TwinT's 23:06:00 08/15/04 Did whomever install them properly? (n/m) - kryptonite729 23:15:43 08/15/04 Re: Did whomever install them properly? - TwinT's 23:23:44 08/15/04 What was the piston to cylinder wall clearance? (n/m) - kryptonite729 23:25:54 08/15/04 Re: What was the piston to cylinder wall clearance? - TwinT's 23:35:46 08/15/04 right, but what was the bore clearance set to? (n/m) - aliaZ (it finally runs) 00:17:14 08/16/04 also, does this happen when the engine is cold? - aliaZ (it finally runs) 00:18:21 08/16/04 i think i do get where your coming from :).... - kryptonite729 07:33:46 08/16/04 if i may ask, what is skirt slap? (n/m) - mousersix (San Antonio) 00:55:41 08/16/04 I do. It started after almost 2000 miles on them, but - boileralum 10:50:31 08/16/04
Post a Followup	You cannot reply to this message because you are not logged in.