Subject	You don't have to pull your rad...
Posted by	DconZ on August 13, 2004 at 6:29 PM
	This message has been viewed 34 times.
In Reply To	FYI-Don't forget to include draining and removing radiator. (n/m) posted by SooperZ95 on August 13, 2004 at 03:12 PM
Message	If you buy a cheap puller and shorten the center bolt you can do it with the rad intact. I just cut a few inches off mine and ground a new end. You do have to be more carefull not to yank it off into your fins! Saves alot of time! I suppose the belts and tension might be easier to set with the rad out but 6 of one....
Follow Ups	How hard is it to instal an underdrive pulley? (n/m) - joshsworld21 13:20:14 08/13/04 not very (n/m) - Joe(NoVA) 13:39:36 08/13/04 depends (n/m) - ZEngineer (TT) 13:43:06 08/13/04 Easy if you have the right tools. (n/m) - SniPer SR71 (Dallas) 13:44:11 08/13/04 pretty easy if you have a pully puller with long claws - big gixx 13:59:08 08/13/04 FYI-Don't forget to include draining and removing radiator. (n/m) - SooperZ95 15:12:29 08/13/04 You don't have to pull your rad... - DconZ 18:29:06 08/13/04 Type in underdrive pulley in SEARCH and read the many - zxjpmzx 14:46:03 08/13/04 About as hard it is for you to spell "install" correctly. - Milo (Sport Z Magazine) 15:36:15 08/13/04 If you have these,, it's a snap - SonicZ 19:15:21 08/13/04
Post a Followup	You cannot reply to this message because you are not logged in.