Subject	I had the HKS one hooked up. I bought the B&M one
Posted by	AzHeat on August 06, 2004 at 3:59 PM
	This message has been viewed 26 times.
In Reply To	Are you saying you are using both? posted by Spongerider :) on August 06, 2004 at 02:54 PM
Message	from Ebay. The HKS one increase the dwell time of the coil which is saturation time. Why couldn't you use both? The 20 volts is going directly to the coil not through the HKS unit. The HKS unit is just the managing the trigger part. Could have best of both worlds.
Follow Ups	pic request: stainless turbo feed oil lines - joel(PA) 10:19:14 08/06/04 I ran mine from teh stock junction block. I used 3 of the - boileralum 10:48:12 08/06/04 I used Goodrich Banjo bolts and fittings. The SS line - AzHeat 13:11:53 08/06/04 Yea, the stock junction block near the bell housing - AzHeat 10:56:41 08/06/04 If you use the HKS banjo fittings, they already have - boileralum 12:58:46 08/06/04 I didn't use HKS banjo bolts. I used a generic one and - AzHeat 13:07:02 08/06/04 Nope, I was merely making the suggestion, which - boileralum 13:17:49 08/06/04 Re: pic request: stainless turbo feed oil lines - Spongerider :) 11:50:20 08/06/04 You beat Bernie on that one .. - PLEAZURE in CA (SD) 12:06:04 08/06/04 i want to see zo's dp's with the wastegate dump - genic 12:27:05 08/06/04 Re: i want to see zo's dp's with the wastegate dump - ZHOUND 13:03:36 08/06/04 I want to see Zo's new ignition amplifier? (n/m) - Spongerider :) 13:11:28 08/06/04 Heheh. - ZHOUND 13:13:24 08/06/04 What is he using? I have the B&M volt and the HKS one - AzHeat 13:13:43 08/06/04 HKS. (n/m) - ZHOUND 13:19:49 08/06/04 Are you saying you are using both? - Spongerider :) 14:54:49 08/06/04 I had the HKS one hooked up. I bought the B&M one - AzHeat 15:59:35 08/06/04 I see (n/m) - Spongerider :) 16:17:59 08/06/04 Lets see some pictures of your Z genic. Are those - AzHeat 13:20:04 08/06/04 his profile is current (n/m) - Guapo 13:26:47 08/06/04 thanks everyone (n/m) - joel(PA) 12:41:04 08/06/04
Post a Followup	You cannot reply to this message because you are not logged in.