Subject	I wouldn't put a whole lot of emphasis into performance
Posted by	Ash's Z (In Progress) on July 24, 2004 at 2:42 PM
	This message has been viewed 143 times.
In Reply To	Hey Ash, just wanted your quick opinion on what performance posted by PiotrC70 on July 24, 2004 at 02:27 PM
Message	with the driveshaft - it is lighter and offers less turning resistance (advantage of eliminating the center universals and CSB), but it isn't large in diameter (as compared to a flywheel or tire) so accelerating its RPM/mass is comparably insignificant. I would have to say that because the OEM DS(CSB) is a common part failure of higher mileage Z's and a new OEM DS is ridiculously priced, its more a matter of convenience/price than for performance. The 1-piece is lighter, rebuildable, and has less moving parts - the fact it is less expensive and could only stand to offer better performance, although likely negligible, I would have to say it is more of a 'convenience part'. [ ashleypowers.com ] [ agpowers@bellsouth.net ] Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor. Albert Einstein
Follow Ups	first step in making intercooler ducts - AvailPunk9 13:50:55 07/24/04 dude just leave them like that... that will work (n/m) - Solidpantz 13:58:38 07/24/04 I was thinking of making up a set a while back for the S14 - Ash's Z (In Progress) 14:03:03 07/24/04 Ash I like your signature link, looks great (n/m) - HakenTT 14:25:30 07/24/04 Thanks! I used a stock font and stole the background tho... - Ash's Z (In Progress) 15:00:52 07/24/04 Hey Ash, just wanted your quick opinion on what performance - PiotrC70 14:27:54 07/24/04 I wouldn't put a whole lot of emphasis into performance - Ash's Z (In Progress) 14:42:11 07/24/04 Understood. I just wanted your opinion on the matter because - PiotrC70 14:47:41 07/24/04 very true... - silverZman 16:26:49 07/24/04 .020 aluminum is too thin - jkeyser14 14:46:03 07/24/04 Yeah, the stuff I was looking at was thicker than 0.020" - Ash's Z (In Progress) 14:49:31 07/24/04 Use plastic epoxy putty to glue the plastic sheets together - Wui (Philly) 14:03:34 07/24/04 g H E T T O! (n/m) - Solidpantz 14:09:53 07/24/04 It is ghetto, but it will work, and unless you have x-ray - Wui (Philly) 15:05:45 07/24/04 hey i used that before, good stuff! =) lol (n/m) - stockplayerz (NYC) 16:14:42 07/24/04 or . . . - robo (sebring1970) 02:14:55 07/25/04 I've got two ideas - jkeyser14 14:43:51 07/24/04 Was wondering when someone would suggest Fiberglass - lazersos 19:39:17 07/24/04 get a plastic welder - dogpile 13:18:45 07/25/04
Post a Followup	You cannot reply to this message because you are not logged in.