Subject	Ya burning up a car with no insurance is never any fun
Posted by	dusthis on July 07, 2004 at 3:17 AM
	This message has been viewed 25 times.
In Reply To	Those are meant to go in the engine bay and not in the cabin posted by SeedyROM on July 07, 2004 at 03:09 AM
Message	I think I'll tape it to the windsheild while checking pressure initionally and then just make a low profile bracket some where. thanks for the info! DusThis Shady Tree mechanic in Orange County; Brakes,Electronics,interior,Fuel,Polishing
Follow Ups	Just pick up the B&M Fuel Pressure gauge,Need mounting ideas - dusthis 02:28:50 07/07/04 i wish i could give you a great idea - Red ZX (SoCal) 03:07:22 07/07/04 Thanks,Kinda what I was thinking.NE danger of possible - dusthis 03:13:40 07/07/04 no fuel lines should go into the cabin... - spyhunter(nj) 06:31:29 07/07/04 Those are meant to go in the engine bay and not in the cabin - SeedyROM 03:09:15 07/07/04 FWIW, my fathers 67 Fastback burned to the ground because - SeedyROM 03:15:20 07/07/04 Ya burning up a car with no insurance is never any fun - dusthis 03:17:38 07/07/04 mechanical fuel pressure gauge mounting location... - dbotos 03:17:14 07/07/04 Cool just what I was looking for! What readings do you - dusthis 03:21:34 07/07/04 see bottom of this page... - dbotos 03:43:10 07/07/04 Good show (n/m) - SeedyROM 03:21:57 07/07/04 and you know what... - Red ZX (SoCal) 03:30:54 07/07/04 you can get a 0-100 psi electric w/ sender for <$80... - dbotos 03:36:51 07/07/04 Very nice. BTW- Your missing a bolt on your coilpack. (n/m) - Milo (Sport Z Magazine) 09:29:11 07/07/04 thanks... - dbotos 14:19:11 07/07/04 on the hood? it'd be cool if it was done right. (n/m) - turbosailor(trans. to Seattle) 07:15:28 07/07/04 Highly recommended that you don't mout it in the - whitepearlz 07:28:01 07/07/04 If you use SS braided line.... - RAGTPZ(OH) 08:28:42 07/07/04 Where did you get the strut tower cover? - govaardz(Aruba) 10:21:03 07/07/04 No doubt - SeedyROM 11:26:07 07/07/04 you should see his cool struts bolts he has now also (n/m) - PLEAZURE in CA (SD) 12:20:11 07/07/04 got those off ebay for like $7, getting one custom fabbed - RAGTPZ(OH) 13:29:14 07/07/04 Cool I fabbed some in Aluminum a while ago (n/m) - govaardz(Aruba) 14:13:50 07/07/04
Post a Followup	You cannot reply to this message because you are not logged in.