TwinTurbo.NET: Nissan 300ZX forum - actually a single turbo Z wouldn't be THAT hard to do
People Seeking Info
 
   


     
Subject actually a single turbo Z wouldn't be THAT hard to do
     
Posted by yellowzxtt on June 08, 2004 at 7:07 PM
  This message has been viewed 115 times.
     
In Reply To Mass Production of Single Turbo Kit? posted by ZRestorer on June 08, 2004 at 11:50 AM
     
Message Put the turbo where the battery currently sits - run the driver side exhaust below the tranny and block. BTW before you say it - equal lenth headers are over rated :)

Custom single 80 mm Q45 TB intake manifold. The turbo outlet running to a single entry FMIC run across to the driver side then out from there to the above mentioned Single TB.

Could it be done ? Yes - Any point to doing it - i don't think so - but its doable :)

Rough costs

Custom intake manifold - $1500
Custom FMIC to support 1000 hp - $1800
Custom headers (use GD inconels + some fabrication) $ 2500
Single turbo T88 Greddy or something - $ 2500
Fully built motor - $ 6000

Harry

" If it doesn't make it faster, i don't care "
Please visit www.ztuner.com to GO FASTER

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.