Subject	dude, if your driving and the timing belt snaps
Posted by	CaptanZap on May 20, 2004 at 5:20 PM
	This message has been viewed 27 times.
In Reply To	Check it out...ask them how they know this....have them show posted by zxjpmzx on May 20, 2004 at 03:36 PM
Message	your engine is toast...... 1990 Stage: Fast TT(Charcoal) 1992 Stage: Fast For A NA(Charcoal) Life Isn't Always White Or Black, Sometimes It's Shades Of 'Charcoal' AIM:Todders 925 ZPYRATE: I Think The Both Of Us Were Better Off With Just NA's. Private Message from the Admins or Moderators The moderation staff has deleted your message Kenny Is Just Plain And Simple Balla' Status posted on 05/07/2004 at 02:22 AM in the General forum for the following reason: ? admin@twinturbo.net
Follow Ups	My Timing Belt Broke - Mny300zx 15:25:58 05/20/04 (bent*)If the belt snapped, they are telling the truth. - mds2004 15:28:20 05/20/04 they aren't lying start looking. - Solidpantz 15:28:24 05/20/04 Check it out...ask them how they know this....have them show - zxjpmzx 15:36:58 05/20/04 dude, if your driving and the timing belt snaps - CaptanZap 17:20:33 05/20/04 I have read here in the Forum that some people report - zxjpmzx 17:31:00 05/20/04 maybe if car is at Idle....but even then - CaptanZap 18:16:57 05/20/04 Did not seem rude to me...appreciate your comments! - zxjpmzx 09:36:59 05/21/04 It sounds legit to me. Usually when it goes, you bend the - Black Mammoth (VA) 15:50:12 05/20/04 it cost my friend about 2k to fix it. (n/m) - Jimina 16:58:34 05/20/04 how is he going to do a compression check? (n/m) - ScubaSteve 18:38:13 05/20/04 How do you normally do a compression check? I guess I don't - Black Mammoth (VA) 07:17:04 05/21/04 you need the timing belt intact to do a compression check - boileralum 09:52:14 05/21/04 valves bent: no lie - RobWR14 17:26:15 05/20/04 Just my .02 - Jason300zxTT(NoVA) 17:54:46 05/20/04 valves have to be replaced but you dont have replace the - Z_LiFe 18:09:52 05/20/04 i had an idler stud break... - spyhunter(nj) 18:38:29 05/20/04
Post a Followup	You cannot reply to this message because you are not logged in.