TwinTurbo.NET: Nissan 300ZX forum - Well, I start with some Bath and Body Works
People Seeking Info
 
   


     
Subject Well, I start with some Bath and Body Works
     
Posted by JayTTZ (SF Bay) on May 12, 2004 at 12:33 AM
  This message has been viewed 53 times.
     
In Reply To EFI wiring harness maintenance... posted by Roo on May 12, 2004 at 12:22 AM
     
Message deep penetrating lotion, rub that on the...... "Keep the harness soft"????? WTF? I hate to tell you, the only was you are going to keep that thing "soft" is to not install it.

The heat generated from the engine bay will do that to it over time. Reduce the heat, and you may see a little improvement, but I doubt it.

As far as the connectors go, it's just something that's going to happen. They are just a poor design in my book. If the person doesn't know how to remove them properly, they will end up breaking them over time.

You don't need to use electrical grease on all connections, they have that little built in seal which is meant to keep moisture out. I would bet you anything, your corroded connectors, if you looked at them, don't have that that little seal anymore...

1991 Twin Turbo

"Utah! Get me two!" - Pappas
Member # 42254

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.