Subject	lol as clear as mud. I'm asking how close the 1.0mm metal
Posted by	bb0ys (MA) on May 05, 2004 at 6:56 PM
	This message has been viewed 17 times.
In Reply To	I was saying to Punk that if / since 1 mm is closest to posted by robo (sebring1970) on May 05, 2004 at 05:49 PM
Message	greddy gasket will make the compression ratio (8.5:1). When the going gets tough, the tough go: "Screw it... I'll let bernie handle this. ADMIN DELETE" - zboost 15:45:05 01/31/04 ECZA Member # 613
Follow Ups	Anyone have a 1.0mm metal gasket in their engine? - bb0ys (MA) 14:35:53 05/05/04 I think that 1.0mm is stock sized (n/m) - PunkZTT(Phoenix) 14:36:53 05/05/04 maybe metal matters most (n/m) - robo (sebring1970) 14:47:01 05/05/04 Do you mean that 1mm metal is closest to stock? (n/m) - bb0ys (MA) 16:15:36 05/05/04 I was saying to Punk that if / since 1 mm is closest to - robo (sebring1970) 17:49:52 05/05/04 lol as clear as mud. I'm asking how close the 1.0mm metal - bb0ys (MA) 18:56:05 05/05/04 Ok well... - PunkZTT(Phoenix) 15:11:19 05/05/04 You'd have to be doing a lot of HG replacements for the - boileralum 15:43:08 05/05/04 It works out :) - PunkZTT(Phoenix) 16:24:41 05/05/04 LMAO (n/m) - ImTheDevil 23:57:34 05/05/04 I'm on my 4th pull, but only second set of headgaskets, - boileralum 00:11:49 05/06/04 Yeah, cracking a head would suck! - PunkZTT(Phoenix) 01:44:56 05/06/04 I have Greddy HG for sale , only used it for 5k. See - AzHeat 17:27:41 05/05/04 I'll pass, but thanks anyway. (n/m) - bb0ys (MA) 17:44:05 05/05/04
Post a Followup	You cannot reply to this message because you are not logged in.