Subject	Honing the block?
Posted by	zspec1 on May 01, 2004 at 1:10 AM
	This message has been viewed 97 times.
Message	Well I finally finished pulling the motors out (will post pics later). When I went to the only Machine shop here in Beaufort,SC they said that they didn't have a torque plate for the VG30 but that it has plenty of webbing in the block that they don't really need one. Now I think I know better than that since I'm going .040 over with the wiseco now my question is: Does anyone no were I may be able to find a place close to beaufort,SC 29906 that will have a torque plate? So far the closest places I know of are Z1&Gin but they are over six hours away(according to Yahoo maps). Thank's for your time. "When you buy a $6,000 Z you get a $6,000 Z; go figure"
Follow Ups	Honing the block? - zspec1 01:10:12 05/01/04 Re: Honing the block? - Halo Z 05:43:16 05/01/04 Georgia, not Alabama ;-) (n/m) - boileralum 13:16:08 05/01/04 what's like 5 miles. (n/m) - Halo Z 13:57:33 05/01/04 A torque plate only costs about $300-350.. just buy one. - Greg (Dallas) 11:57:53 05/01/04 2nd... - Snoguitar 15:04:54 05/01/04
Post a Followup	You cannot reply to this message because you are not logged in.