| relavent, and irrelevent; If I were to build a 'single car' workshop as you have stated, i'd go with depth....
my garage is 20 feet deep x 22 feet wide.
the pseudo work bench in the picture is 2 feet deep.
with the car set back with about 6" to clear the garage door, I don't have 'plenty' of room. I have room obviously, but not plenty. 
As far as width, I can park my car at an angle (as noted in the photo), and still open 3 of 4 doors when two vehicles are in the garage.
dunno if this helps, but imagine the center line being the kitchen door there... thats 11 feet wide.
I think going for 15 feet wouldn't too bad at all. 
disclaimer:
I apologize for the mess. I was mudding all weekend trying to finish the walls and ceiling to prepare for paint. :Let's just say you were to build a workshop/garage thing in your yard. Not worrying about tool storage.
:How much 'wiggle' room is adequate to work around a car?
:6 feet on each side and front/rear of the car?
:Is 20x15 enough space for working on a Z? or an RX7? ;)
:
"As the Z32 gets older and decreases in value it becomes affordable by lower income and often less desirable people whose tastes reflect their personality and social standing.- Marshall 17:37:05 10/10/03Petz #3
|
nzr; - 
