TwinTurbo.NET: Nissan 300ZX forum - i'm not fond of GC either, but part of the reason the assemb
People Seeking Info
 
   


     
Subject i'm not fond of GC either, but part of the reason the assemb
     
Posted by Z U N L on April 13, 2004 at 9:57 PM
  This message has been viewed 46 times.
     
In Reply To Re: "I don't like the ground control type"...why is that..I have posted by zeeextreme on April 13, 2004 at 09:50 PM
     
Message part of the reason the assembly separated when the car was lifted is that the spring rate may not have been stiff enough or the springs were a bit too short. my spring rate is rather soft, and if i were to keep the perch threaded all the way down rather than all the way up, it would probably be more prone to separate, but while it is threaded to the top, there is ample pressure to hold the spring assembly tight.



"The two seater is being joined in a few weeks by a larger two-plus-two model with a rear seat for munchkins." ~Jim Mateja, Chicago Tribune, in regards to the Z32.

Andrew Janeshek // jnshk@aol.com // 1992 NA 2+2 [Stage 2-ish]
Click here for my home page.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.