Subject	I am using ARP studs. You use the ARP grease when
Posted by	AzHeat on April 08, 2004 at 7:11 PM
	This message has been viewed 29 times.
In Reply To	Do you put all those studs in the block like that so you can posted by Zenn on April 08, 2004 at 07:06 PM
Message	torquing them down. It takes slightly less torque than using bolts because there is less friction to overcome. I think the specs I got was 87 ft.lbs. stock is 90 ft.lbs. not much difference.
Follow Ups	Got some new parts!! pics inside - NA300zOH 19:00:59 04/08/04 Do you put all those studs in the block like that so you can - Zenn 19:06:40 04/08/04 I am using ARP studs. You use the ARP grease when - AzHeat 19:11:33 04/08/04 it came with bolts stock, studs are a replacement for - NA300zOH 19:12:31 04/08/04 Thanks (n/m) - Zenn 19:24:57 04/08/04 Why didn't you paint the block first before assembling - AzHeat 19:09:18 04/08/04 i am not assembling yet, i am gonna paint it before i - NA300zOH 19:13:57 04/08/04 just wondering, cause you had the studs installed (n/m) - AzHeat 19:18:49 04/08/04 man i gotta do a search. - Jason300zxTT(NoVA) 20:48:27 04/08/04 Im almost positive JE has stock size pistons (n/m) - NA300zx (OH) 20:50:54 04/08/04 what compression ratio? (n/m) - CarlCuro 21:59:23 04/08/04 10.5:1, same as stock (n/m) - NA300zx (OH) 06:44:26 04/09/04
Post a Followup	You cannot reply to this message because you are not logged in.