Subject	Brazing Question?
Posted by	PunkZTT(Phoenix) on April 08, 2004 at 5:12 PM
	This message has been viewed 23 times.
In Reply To	I brazed mine. You might try soldering, which is easier. (n/m) posted by AzHeat on April 08, 2004 at 12:03 PM
Message	Is braing the process that you use to join copper pipes? IE you sand down the two parts until they are shiny, add flux to them, heat up the metal with a blowtorch, and then meld the solder onto the pipe? - Currently Broken
Follow Ups	Adapting SS Fuel Lines w/ AN fittings to the Stock Rail?? - PunkZTT(Phoenix) 01:38:55 04/08/04 The problem you will have is room. Once you put the - kingtut(So.Cal) 11:16:29 04/08/04 I am in the same boat, but......had some concenrs> - spotz 14:49:48 04/08/04 If you support the brazed on fitting with a wrench while you - kingtut(So.Cal) 15:00:41 04/08/04 I brazed mine. You might try soldering, which is easier. (n/m) - AzHeat 12:03:44 04/08/04 Brazing Question? - PunkZTT(Phoenix) 17:12:12 04/08/04 yes. (n/m) - TTony 19:43:05 04/08/04
Post a Followup	You cannot reply to this message because you are not logged in.