Subject	If you support the brazed on fitting with a wrench while you
Posted by	kingtut(So.Cal) on April 08, 2004 at 3:00 PM
	This message has been viewed 25 times.
In Reply To	I am in the same boat, but......had some concenrs> posted by spotz on April 08, 2004 at 02:49 PM
Message	tighten the earls fitting to the rail you should be fine. I cut the fuel rail down on the feed side and it is thicker than I thought. Are you sticking with the stock fpr and dampeners? 1990 Auto TT Stage XI+++ no nos 2002 Dodge Ram 1500 Quad Cab Sport
Follow Ups	Adapting SS Fuel Lines w/ AN fittings to the Stock Rail?? - PunkZTT(Phoenix) 01:38:55 04/08/04 The problem you will have is room. Once you put the - kingtut(So.Cal) 11:16:29 04/08/04 I am in the same boat, but......had some concenrs> - spotz 14:49:48 04/08/04 If you support the brazed on fitting with a wrench while you - kingtut(So.Cal) 15:00:41 04/08/04 I brazed mine. You might try soldering, which is easier. (n/m) - AzHeat 12:03:44 04/08/04 Brazing Question? - PunkZTT(Phoenix) 17:12:12 04/08/04 yes. (n/m) - TTony 19:43:05 04/08/04
Post a Followup	You cannot reply to this message because you are not logged in.