Subject	I brazed mine. You might try soldering, which is easier. (n/m)
Posted by	AzHeat on April 08, 2004 at 12:03 PM
	This message has been viewed 20 times.
In Reply To	Adapting SS Fuel Lines w/ AN fittings to the Stock Rail?? posted by PunkZTT(Phoenix) on April 08, 2004 at 01:38 AM
Message
Follow Ups	Adapting SS Fuel Lines w/ AN fittings to the Stock Rail?? - PunkZTT(Phoenix) 01:38:55 04/08/04 The problem you will have is room. Once you put the - kingtut(So.Cal) 11:16:29 04/08/04 I am in the same boat, but......had some concenrs> - spotz 14:49:48 04/08/04 If you support the brazed on fitting with a wrench while you - kingtut(So.Cal) 15:00:41 04/08/04 I brazed mine. You might try soldering, which is easier. (n/m) - AzHeat 12:03:44 04/08/04 Brazing Question? - PunkZTT(Phoenix) 17:12:12 04/08/04 yes. (n/m) - TTony 19:43:05 04/08/04
Post a Followup	You cannot reply to this message because you are not logged in.