Subject	Adapting SS Fuel Lines w/ AN fittings to the Stock Rail??
Posted by	PunkZTT(Phoenix) on April 08, 2004 at 1:38 AM
	This message has been viewed 106 times.
Message	Has anyone ever done this using compression fittings? I have searched all over the internet for AN compression fittings and I have only found one example... [ http://www.ronmorrisperformance.com/04fuel/fittings.htm ] (3/4 down the page) I know that compression fittings are usually good to at least 200 psi, so I am pretty sure they can hold the pressure. This seems like a more viable option than welding AN fittings to the rails. Any Ideas? - Currently Broken
Follow Ups	Adapting SS Fuel Lines w/ AN fittings to the Stock Rail?? - PunkZTT(Phoenix) 01:38:55 04/08/04 The problem you will have is room. Once you put the - kingtut(So.Cal) 11:16:29 04/08/04 I am in the same boat, but......had some concenrs> - spotz 14:49:48 04/08/04 If you support the brazed on fitting with a wrench while you - kingtut(So.Cal) 15:00:41 04/08/04 I brazed mine. You might try soldering, which is easier. (n/m) - AzHeat 12:03:44 04/08/04 Brazing Question? - PunkZTT(Phoenix) 17:12:12 04/08/04 yes. (n/m) - TTony 19:43:05 04/08/04
Post a Followup	You cannot reply to this message because you are not logged in.