Subject	chris, when u get the motor fixed and u go for the 1st drive
Posted by	Borg79(ON) on April 03, 2004 at 5:20 PM
	This message has been viewed 20 times.
In Reply To	Day one: posted by Chris(NJ) on April 03, 2004 at 05:18 PM
Message	you will realize all the pain and hard work is worth it in the end :) I went through the same thing :) -"Chains baby, chains.......Z will grip like a champ. (n/m) - Wolf [Pittsburgh] 14:56:58 05/10/00" How to Check Turbos: "1st remove exhaust and pre-cats. Then fire that mother up, rev it to at least 5000 rpm and then stick your finger into the hole on the back of the turbo. If the turbine grinds your finger down, then your turbo is working. If your finger gets ground off farther than the second knuckle, then your turbos are good for at least another 60k miles! Don't forget to check both sides." -I am Z-ing Double -"The world's two biggest mysteries: The meaning of life and fitting the Howe radiator into the Z..." -Seedyrom, circa 2000
Follow Ups	Day one: - Chris(NJ) 17:18:02 04/03/04 chris, when u get the motor fixed and u go for the 1st drive - Borg79(ON) 17:20:13 04/03/04 oh god..."slow and steady wins the race"? - Zeus 17:21:04 04/03/04 Lookin good! Keep it up as long as you have the energy. - -Ever- 17:27:03 04/03/04 very cool bro - good start! (n/m) - Wagz 17:33:37 04/03/04 Good job! (n/m) - ZEngineer 17:33:44 04/03/04 Why did you remove the front facia and head lights? (n/m) - AzHeat 17:35:20 04/03/04 Why not, it only takes a few minutes and really lets you - whitepearlz 17:48:03 04/03/04 Left mine on, not one scratch. Pulled motor tranny - AzHeat 18:30:35 04/03/04 nice rim (n/m) - frladyZ 20:42:12 04/03/04 Since his car was just painted... - MyWhiteZTT(NJ) 18:07:41 04/03/04 "eric and i" - dogpile 17:39:45 04/03/04 good luck man. (n/m) - JuicycJ4(SWMO) 17:49:54 04/03/04 Sweet deal, hope everything turns out good. (n/m) - Southern_Z [IL] 19:57:20 04/03/04 manual labor has it's rewards good luck!! (n/m) - JDMz32smity 20:15:46 04/03/04 so are you keeping it or what? - imahurtchu 21:27:55 04/03/04 Since the engine coming out, plan to paint the engine bay? (n/m) - Wui (Philly) 22:19:43 04/03/04 i dont think so. It's juts another cost i dont need (n/m) - Chris(NJ) 08:49:47 04/04/04 The Z has some really sharp interior pieces, I found out - BigTDogg (MA) 22:51:43 04/03/04 compression was great on pass. side, drive side was 85/125/0 (n/m) - Chris(NJ) 08:48:33 04/04/04 #6? (n/m) - BigTDogg (MA) 22:55:07 04/04/04 w00t w00t, best of luck Chris! (n/m) - Red ZX (SoCal) 00:32:17 04/04/04 Good luck man! (n/m) - zboost(TX) 08:20:00 04/04/04
Post a Followup	You cannot reply to this message because you are not logged in.