Subject	Unless its thinner than 18 ga. you should be fine.
Posted by	T0M on March 30, 2004 at 3:46 PM
	This message has been viewed 29 times.
In Reply To	RVM aluminum hardpipes and HKS BOV flange compatability? >>> posted by whitepearlz on March 30, 2004 at 03:42 PM
Message	16 gauge would be better, if your lucky its 6061 or 5052. It wouldnt suprise me if RVM used a lower grade though. Fwiw a Tig welder can weld two pieces of aluminum foil together. AIM: TDMGR33N
Follow Ups	RVM aluminum hardpipes and HKS BOV flange compatability? >>> - whitepearlz 15:42:00 03/30/04 Unless its thinner than 18 ga. you should be fine. - T0M 15:46:20 03/30/04 Thank you, I may go that route then. (n/m) - whitepearlz 16:40:45 03/30/04 I like how your Engine bay looks, that color scheme is - racespecifications 17:42:02 03/30/04 It can be TIG welded if you have a contact to get it done, - Scotts94z32 17:53:05 03/30/04 Thank you, I'm going to try and locate someone - whitepearlz 18:19:10 03/30/04 I have BOVs welded to my RVM hardpipes. - Chip(GMS Racing) 22:24:58 03/30/04 Thanks Chip, just what I needed to hear! (n/m) - whitepearlz 23:12:11 03/30/04
Post a Followup	You cannot reply to this message because you are not logged in.