Subject	RVM aluminum hardpipes and HKS BOV flange compatability? >>>
Posted by	whitepearlz on March 30, 2004 at 3:42 PM
	This message has been viewed 321 times.
Message	For those who have seen these, or know anything about welding aluminum > The RVM hardpipes are aluminum, and *fairly* thin. Am I correct in thinking that they would not support the welding, and weight of an SSQV BOV and flange? I was going to go that route, but bought the recirc flanges instead. I would, however, mount them on the hard pipes if I knew it was possible. Alas, I don't know anything about welding aluminum (yet)... Here is a picture of the RVM hardpipes installed on my Z, for reference: . . Thanks, ~Mike
Follow Ups	RVM aluminum hardpipes and HKS BOV flange compatability? >>> - whitepearlz 15:42:00 03/30/04 Unless its thinner than 18 ga. you should be fine. - T0M 15:46:20 03/30/04 Thank you, I may go that route then. (n/m) - whitepearlz 16:40:45 03/30/04 I like how your Engine bay looks, that color scheme is - racespecifications 17:42:02 03/30/04 It can be TIG welded if you have a contact to get it done, - Scotts94z32 17:53:05 03/30/04 Thank you, I'm going to try and locate someone - whitepearlz 18:19:10 03/30/04 I have BOVs welded to my RVM hardpipes. - Chip(GMS Racing) 22:24:58 03/30/04 Thanks Chip, just what I needed to hear! (n/m) - whitepearlz 23:12:11 03/30/04
Post a Followup	You cannot reply to this message because you are not logged in.