Subject	For those who've installed strut tower braces...
Posted by	Wild Z on January 24, 2001 at 12:47 PM
	This message has been viewed 19 times.
Message	I know that holes need to be cut in the plastic panels (inside rear)... has anybody found a way to "clean up" these holes so they look nice? Any suggestions - or is the gaping hole the only option. Thanks!
Follow Ups	For those who've installed strut tower braces... - Wild Z 12:47:14 01/24/01 Vitessi Motorsports is working on one you dont see - genic 12:54:09 01/24/01 seems one could turn the strut bar upside down... - Technomancer 22:21:04 01/24/01 Go here>>> - JRH(KY) 13:07:10 01/24/01 yep, use door edge trim on holes>> - twinz 13:16:34 01/24/01 how about leather boot around the bracket like shifter (n/m) - MikeH(Phoenix) 16:03:22 01/24/01 Wait until i get my Dremel, i've got something else in mind - chivas 21:55:10 01/24/01
Post a Followup	You cannot reply to this message because you are not logged in.