Subject	I dont have a FMIC but the way I did mine would work
Posted by	DAYTONAZ on March 19, 2004 at 7:51 PM
	This message has been viewed 25 times.
In Reply To	Thanks, this is just more and more work. (n/m) posted by RemodeledZ on March 19, 2004 at 07:22 PM
Message	You can search my posts and find some pics. Basically you will swap the valves left to right & right to left. This takes the valve from a low mounted position to a high mounted position just below the headlight buckets. You will need to cut off the L-bracket that is welded to the chrome pipe on the valve. Then install a clamp around the body of the valve and secure it to the headlight bucket. I used an Adel clamp which is just a circular rubber lined clamp used in aviation. I did have to drill 1 hole through the headlight bucket to fasten the clamp. They have worked fine with no problem and what I also like is this position keeps them high and out of the elements.
Follow Ups	So how do you get Apex BOV's in with a FMIC? (n/m) - RemodeledZ 19:15:53 03/19/04 u end up having to refit them & do some adjusting/cutting - Wagz 19:21:06 03/19/04 Thanks, this is just more and more work. (n/m) - RemodeledZ 19:22:15 03/19/04 I dont have a FMIC but the way I did mine would work - DAYTONAZ 19:51:10 03/19/04 you have to turn them up instead of down. (n/m) - AzHeat 19:23:58 03/19/04 depending on the FMIC "you dont" - Jason300zxTT(NoVA) 21:22:58 03/19/04
Post a Followup	You cannot reply to this message because you are not logged in.