Subject	Stuck Drive shaft bolts.....
Posted by	onebadbug on March 09, 2004 at 7:14 PM
	This message has been viewed 57 times.
Message	Okay here we are all ready to yank it and the only thing holding me up is THE STUPID DRIVE SHAFT SUPPORT!! I had an imapct on each bolt for 5 minutes and nothing!!! Heated them for a couple mins and Still nothing!! Then got a 1/2" breaker bar with a 3 foot cheater pipe on it and still NOTHING!! These are the only thing preventing the yank and I'm baffled with these anyoe have any suggestions to get them off? I am letting them soak in wd40 overnight and am gonna try again tommorow when we get off work. If anyone else has a trick or tip offer it up I would really hate to even think about trying to cut through the bracket GRS
Follow Ups	Stuck Drive shaft bolts..... - onebadbug 19:14:48 03/09/04 Re: Stuck Drive shaft bolts..... - Spddracer 20:07:43 03/09/04 Use PB Blaster and impact. (n/m) - cshell 20:57:36 03/09/04
Post a Followup	You cannot reply to this message because you are not logged in.