Subject	Question about sanding/grinding plenum
Posted by	ScubaSteve on March 08, 2004 at 5:01 PM
	This message has been viewed 104 times.
Message	When I sand the plenum down, the metal shavings/grindings will get inside the plenum in balance tube hole or TB holes. When it goes back on the motor, how can I make really sure all the debri is cleaned out? I have a feeling blasting a garden hose in it will not be enough, metal sandings always seem to stick to surfaces really good. If honing the inside of the plenum is not too expensive I'll just do that. How much is it usually? Thanks --.scubasteve.--
Follow Ups	Question about sanding/grinding plenum - ScubaSteve 17:01:01 03/08/04 spray it down with PLENTY of carb cleaner. - nixit 17:02:50 03/08/04 thanks, but i dunno that makes me nervous (n/m) - ScubaSteve 17:09:09 03/08/04 Buying 20 cans of carb cleaner? - nixit 17:11:04 03/08/04 prolly nervous about USING 20 cans of carb cleaner *dizzy* (n/m) - T0M 17:14:12 03/08/04 No he's worried about eviromental pollution ..he can't Scuba - PLEAZURE in CA (SD) 18:46:04 03/08/04 well, whatever... brake parts cleaner or carb cleaner is - nixit 17:17:20 03/08/04 compressor......air nozzle........or vaccuum...or both. (n/m) - BooZted (Soon supercharged) 17:02:54 03/08/04 Lol. Good luck with your project. Quack. (n/m) - nixit 17:03:38 03/08/04 Oh, why thank you. (n/m) - BooZted (Soon supercharged) 17:08:09 03/08/04
Post a Followup	You cannot reply to this message because you are not logged in.