Subject	I'm fairly sure that is your problem, especially
Posted by	VECTOR on March 06, 2004 at 12:27 PM
	This message has been viewed 152 times.
In Reply To	i got my pistons on a group by last summer... posted by Slowninja(Sport600 Inconel Z) on March 06, 2004 at 11:00 AM
Message	if they were coated the clearances specified by Wiseco on their old design are too high. Machine shops shouldn't be blamed unless they installed the offsets wrong. There is a nipple on the bot. of the pistons that goes opp. of engine rotation. Good luck, George
Follow Ups	another machine shop another motor knock (rant) - Slowninja(Sport600 Inconel Z) 19:37:51 03/05/04 ROFL....but I'd miss my dog (n/m) - TARGETZ 19:42:21 03/05/04 Sorry to hear that :( Maybe a new short block? (n/m) - Wui (Philly) 19:45:56 03/05/04 Machinist are almost perfect - TTnutz 19:47:25 03/05/04 on a fresh short block ..i got the flash casting removed - Slowninja(Sport600 Inconel Z) 20:22:54 03/05/04 What exactly are you experiencing... - VECTOR 04:06:58 03/06/04 i got my pistons on a group by last summer... - Slowninja(Sport600 Inconel Z) 11:00:10 03/06/04 I'm fairly sure that is your problem, especially - VECTOR 12:27:33 03/06/04 Damn Dee, Sorry you have to go through that S#$T - AeroMODIFIER(2530's) 20:05:04 03/05/04 Sorry, not what you want to hear but I cant see the problem - ZisLuv 21:12:04 03/05/04 why am i going apeshit ??? sounds like the machine shop - Slowninja(Sport600 Inconel Z) 11:08:12 03/06/04 I'm really sorry to hear about your touble. FWIW this is - RegalZ 22:30:21 03/05/04 thanks for the feedback ..i remember when your car was there (n/m) - Slowninja(Sport600 Inconel Z) 11:10:22 03/06/04 might wanna just send it to greg dupree. - Chris(NJ) 22:51:15 03/05/04 Did you get the z1 spec pistons ? The newer ones have - AzHeat 02:05:37 03/06/04
Post a Followup	You cannot reply to this message because you are not logged in.