Subject	Re: Cool, it seems easy enough.
Posted by	SpeedyTTZ on March 03, 2004 at 8:35 PM
	This message has been viewed 33 times.
In Reply To	Cool, it seems easy enough. posted by guerrieri on March 03, 2004 at 08:33 PM
Message	the angle of the bracket that its in is not the same as the OEM version. So I just improvised. Simple yet effective and easier to get around to adjusting fuel pressure. i have a question about TD05s-hot90tt(underconstruction) i got $5 says u fuck this up too - Wagz ------------------------------------------------------------ "Long story short my boost guage was off i think a couple psi and then the bulb went out on it that night. So I used a flashlight to read what my boost was. Looked like 19 pounds, but I guess I was wrong. Then to top it off, I was bouncing off the rev limiter and powershifted to third. And then the big boom. To my amazement, the next morning it acutlly started!!!! then I shut it off a couple secs later it was killing me to hear what it sounded like." - Posted by: hot90tt(underconstruction) on January 19, 2004 at 11:15 AM
Follow Ups	Nismo FPR - guerrieri 18:57:12 03/03/04 Heres what I did to install mine. - SpeedyTTZ 20:27:16 03/03/04 Cool, it seems easy enough. - guerrieri 20:33:59 03/03/04 Re: Cool, it seems easy enough. - SpeedyTTZ 20:35:46 03/03/04 Sounds good, thanks for the help (n/m) - guerrieri 20:39:03 03/03/04 i always thought that was supposed to mount in the stock - whitepearlz 20:39:47 03/03/04 All the ads that I have seen say it mounts in the stock - guerrieri 20:41:42 03/03/04 the adj screw would hit the coil pack plug. - Halo Z 21:19:52 03/03/04 Do you flow numbers for you heads? I got mine ported - AzHeat 20:57:42 03/03/04 Nope, running on stock internals so far, - guerrieri 21:07:45 03/03/04 Here are my figures for my heads that were done. - SpeedyTTZ 21:20:50 03/03/04 Very interesting, any dyno comparisions to stock head setup? (n/m) - guerrieri 21:29:59 03/03/04 At what depression? - safZ 09:50:24 03/04/04 I have before and after numbers , with stock valves - AzHeat 10:33:13 03/04/04
Post a Followup	You cannot reply to this message because you are not logged in.