TwinTurbo.NET: Nissan 300ZX forum - BB units are very costly to rebuild ( down fall )
People Seeking Info
 
   


     
Subject BB units are very costly to rebuild ( down fall )
     
Posted by ZBlacktt on February 20, 2004 at 6:44 PM
  This message has been viewed 68 times.
     
In Reply To Re: Thanks! Excellent write-up! posted by BryZ32TT on February 20, 2004 at 05:11 PM
     
Message You will most likely see may saying their not rebuilable. But when I looked more into this long ago. I found out that this means that the cost of rebuilding the center section is about 90% of what the whole turbo would cost to buy brand new all over again. The tolerance factors of ball bearings will wear faster than the Mitsu turbo's that utilize a large free-floating bushing type with an extra large center shaft center section. Unless you pay an even higher price for ceramic ball bearing turbo's. This is just one of the things to consider when going the BB route.

Seems like a lot of Supra's reply on Greddy turbo's or Non BB turbo's over BB's.

STAGE V++++
Going to XV+ and beyond :)

Yellow Z STAGE II
Going to XI+

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.