Subject	Why would the story be any different?
Posted by	Marshall on February 17, 2004 at 5:00 PM
	This message has been viewed 39 times.
In Reply To	Key words posted by NytWolf on February 17, 2004 at 04:35 PM
Message	I've pressed out plenty of things and it won't make a bit of difference what condition the material is in. You use a cylinder with an outside diameter that's slightly smaller than the inside diameter of the hole, and it'll punch through whatever's in there.
Follow Ups	Taking out subframe bushings, peace of cake for me - HakenTT 16:17:13 02/17/04 Previous owner probably had them changed, which would - ENVYMYZ 16:25:27 02/17/04 That's a big "probably", maybe UFO's helped him too :) (n/m) - AzHeat 18:34:36 02/17/04 God knows everyone and their mother has a press *rolls eyes* (n/m) - Nexusbeta 16:25:42 02/17/04 Exactly my point as well. (n/m) - YugoBernie (NoVA) 16:27:18 02/17/04 If you want to do a job right, you need the right tools. - Marshall 16:56:39 02/17/04 Harbor Freight sells presses, no excuse just like - AzHeat 18:28:48 02/17/04 A press is large and takes up space - you need a garage - YugoBernie (NoVA) 19:21:26 02/17/04 There are smaller presses that fit on your work bench (n/m) - AzHeat 19:53:06 02/17/04 Again - work bench = garage. (n/m) - YugoBernie (NoVA) 20:17:45 02/17/04 Guess you need a garage too for a bench vice too? - AzHeat 21:55:27 02/17/04 Yeah, but you cheated, you took the subframe completely - DAYTONAZ 16:29:49 02/17/04 I', going to use the nut/bolt/pipe combo to pull the - DAYTONAZ 16:34:22 02/17/04 when I was looking into it many people had said... - TagZ 16:34:34 02/17/04 Key words - NytWolf 16:35:43 02/17/04 Why would the story be any different? - Marshall 17:00:52 02/17/04 B/c the original sleeves are to stay in the subframe (n/m) - NytWolf 17:05:30 02/17/04 ... - Spee 17:09:34 02/17/04 2nd (n/m) - volcomstone550 17:10:40 02/17/04 that looks really good right now (n/m) - Red300ztt96 17:14:56 02/17/04 Content B+ Presentation: F- (n/m) - shirow 17:30:53 02/17/04
Post a Followup	You cannot reply to this message because you are not logged in.