Subject	Hate to knock your choices but.....
Posted by	Rob.M @ Downshift Magazine on February 09, 2004 at 7:24 AM
	This message has been viewed 65 times.
In Reply To	What opinions do you guys have on these wheels? posted by mxsprocket1(TT motor?) on February 08, 2004 at 06:28 PM
Message	You really need to get a wheel that is made for a rwd car. Wheels, are very important that you do it right, just like brakes. You want to look for something that has the proper offset, width and very importantly a wheel that is light. Look for something along the lines of the SSR Integrals, ENkei RPO1, Enkei RPM2, etc.. The integrals are discontinued but used ones are around, as are the RP01's. The RPM2 is a current wheel by Enkei. Just some suggestions. 1994 300ZX ---- 1993 MR2 -------------------------------------- Editor-in-Chief Down Shift Magazine www.DownShiftOnline.com ECZA Florida Chapter President www.ecza-fl.com --------------------------------------
Follow Ups	What opinions do you guys have on these wheels? - mxsprocket1(TT motor?) 18:28:04 02/08/04 Re: What opinions do you guys have on these wheels? - Magnum 18:28:59 02/08/04 im really leaning more towards them also (n/m) - mxsprocket1(TT motor?) 18:32:27 02/08/04 Any photoshoppers out there that can put this on a white z? - mxsprocket1(TT motor?) 18:29:42 02/08/04 2nd on Magnum's comment. (n/m) - Red ZX (SoCal) 18:30:01 02/08/04 #1 (n/m) - sfpearl300z 18:33:09 02/08/04 None, they're all too narrow (n/m) - Scott (NC) 18:43:22 02/08/04 #1 (n/m) - my1st_tt 18:45:17 02/08/04 #1, but like like Scott(NC) said, too narrow - komplexZ 18:54:57 02/08/04 Too positive offset and only 7.5" wide....not good choice. (n/m) - ScreemZ 19:17:34 02/08/04 Too narrow and made for front wheel drive Hondas. (n/m) - YugoBernie (NoVA) 21:34:47 02/08/04 don't buy knockoffs. get real SSR GT1s (n/m) - Spee 00:17:57 02/09/04 Hate to knock your choices but..... - Rob.M @ Downshift Magazine 07:24:47 02/09/04
Post a Followup	You cannot reply to this message because you are not logged in.