TwinTurbo.NET: Nissan 300ZX forum - Are the Sub 4ohm DVCs or the Special 2ohm DVCs?
People Seeking Info
 
   


     
Subject Are the Sub 4ohm DVCs or the Special 2ohm DVCs?
     
Posted by oakleyguy(Rebuild Complete!!) on February 04, 2004 at 12:54 PM
  This message has been viewed 21 times.
     
In Reply To Car audio Gurus! What are your thoughts on these 2 amps? posted by 1tym on February 04, 2004 at 03:41 AM
     
Message If they are four than you want to make sure that the Amps are going to be One ohm stable, which I'm pretty sure nither of these are.
What you need with two 4 ohm DVCs is a large 2 channel amp.
You can wire each sub in series and then wire the two in Parralell, which will yield a 4 ohm load, perfect for a bridged two channel amp.
Otherwise to use a momoblock amp that is stable at 2 ohms, then you need the Special edition Type R, which are 2 ohm DVCs.

Plus, Xtant = Mtx, exact same stuff, made by the Mitek corporation. Go MTX, cheaper, but just as good.

Sig Starts Here *

Yeah putting the engine in and tranny in was this.\/

"Yes, I did pass you on a hill, deal with it"

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.