Subject	More pictures of the blow through mass
Posted by	MikeH(Twin GT35BB Incon Z) on January 30, 2004 at 1:11 AM
	This message has been viewed 117 times.
Message	Notice how there is no hot wire in the middle obstruct air stream. This goes on the pressures side of forced induction system. [ http://www.pro-flow.com/images/UNIVER%20PIC.jpg ]
Follow Ups	More pictures of the blow through mass - MikeH(Twin GT35BB Incon Z) 01:11:47 01/30/04 Re: More pictures of the blow through mass - twinzak 11:47:32 01/30/04 A map sensor is measuring manifold pressure not flow. - MikeH(Twin GT35BB Incon Z) 15:51:58 01/30/04 George tried that route (aftermarket MAFS) but could not - Chip(GMS Racing) 13:07:38 01/30/04
Post a Followup	You cannot reply to this message because you are not logged in.