Subject	put two flywheel bolts 180 degrees apart in the crank
Posted by	MikeH(Twin GT35BB Incon Z) on January 22, 2004 at 5:56 PM
	This message has been viewed 30 times.
In Reply To	how do I hold on to the FW? (n/m) posted by ZEngineer on January 22, 2004 at 05:45 PM
Message	shaft. Use a long prybar to fit inbetween the two bolts. Put transmission bolt in one of the holes on the block. As the crank turns it will turn the prybar and stop at the transmission bolt.
Follow Ups	how would you remove your crank pulley - ZEngineer 17:41:37 01/22/04 Impact Gun or replace FW. (n/m) - YugoBernie (NoVA) 17:42:20 01/22/04 how do I hold on to the FW? (n/m) - ZEngineer 17:45:35 01/22/04 n00b - Guapo 17:47:23 01/22/04 That thing Ownz all. (n/m) - YugoBernie (NoVA) 17:47:46 01/22/04 2nd (n/m) - Spee 17:48:54 01/22/04 woah! I never even knew that existed!! Cooool (n/m) - ZEngineer 17:48:33 01/22/04 put a bolt in a tranny hole and have someone wedge a screw - YugoBernie (NoVA) 17:48:31 01/22/04 NO WAY! - ZEngineer 17:50:33 01/22/04 Dont worry you wont have to ask - TARGETZ 18:17:43 01/22/04 put two flywheel bolts 180 degrees apart in the crank - MikeH(Twin GT35BB Incon Z) 17:56:41 01/22/04 I thought about that - ZEngineer 17:58:19 01/22/04 Re: how would you remove your crank pulley - Duane 17:54:46 01/22/04 that's a terrific idea...thanks! (n/m) - ZEngineer 17:55:59 01/22/04 Re: that's a terrific idea...thanks! - Duane 17:59:30 01/22/04 try this - The-FActor 19:13:14 01/22/04 yeah, that's good but see my answer to MikeH above (n/m) - ZEngineer 20:38:31 01/22/04 I dunno *shrug* As you say, "we Cali guys are soft" - Scotts94z32 19:42:58 01/22/04 why dont you go sit on your mechanic's lap ;) (n/m) - ZEngineer 20:39:34 01/22/04 I would, but your gf is on my lap right now, so I can't. (n/m) - Scotts94z32 11:52:33 01/23/04
Post a Followup	You cannot reply to this message because you are not logged in.