TwinTurbo.NET: Nissan 300ZX forum - I needed to put my stock chip back in, but the leads were
People Seeking Info
 
   


     
Subject I needed to put my stock chip back in, but the leads were
     
Posted by NC-Z on January 20, 2004 at 7:41 PM
  This message has been viewed 29 times.
     
In Reply To One question ........ Why is it raised? (n/m) posted by 400zx on January 20, 2004 at 06:25 PM
     
Message either bent, broken, or covered in solder. I snipped the ends of a bunch of resistors and soldered one end to each eprom lead, and stuck the other end into the eprom socket. It worked, but I'm not driving with it like that. One big bump and my solder may go south.


Know of any Jobs, seriously??
- BS in Industrial Technology with a concentration in Industrial Distribution
- http://www.sit.ecu.edu/ITEC/distribution.htm
- Graduating May 2004

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.