Subject	Had the Greddy profec B and Greddy turbo timer.
Posted by	Milo (Sport Z Magazine) on January 20, 2004 at 1:53 PM
	This message has been viewed 53 times.
In Reply To	Electronics install Q's posted by 15zcar on January 20, 2004 at 12:56 PM
Message	I pulled the glove box out completely cut a circular hole in rear to run the harnesses out and then just drilled the holes (after marking them). Then I used the black screws and a midget phillips and screwed the brackets in. Pretty simple for this basic install. If you want something different, I saw a full glove box panel that I think Striclty Z sells/sold a while back. Very nice piece, but haven't seen it in a while. WELCOME TO TEXAS, YA'LL!!!
Follow Ups	Electronics install Q's - 15zcar 12:56:58 01/20/04 Didn't Stillen do that from day 1? (n/m) - NytWolf 13:03:55 01/20/04 considered putting BC there, but put it under the center- - Scotts94z32 13:04:56 01/20/04 here is the link: - Scotts94z32 13:05:46 01/20/04 Had the Greddy profec B and Greddy turbo timer. - Milo (Sport Z Magazine) 13:53:50 01/20/04 got any pics of them? (n/m) - 15zcar 14:58:37 01/20/04 Here you go... - AnimalZTT (TX) 16:15:12 01/20/04
Post a Followup	You cannot reply to this message because you are not logged in.