Subject	Dr. FAB strikes again. Cheap testpipe-esque mod, Addendum A.
Posted by	AshsZ on January 18, 2004 at 11:48 PM
	This message has been viewed 314 times.
Message	Addendum A: Once midpipe cats were gutted and the chambers were stuffed with a custom-cut pipe insert, the other end of this pipe was rattling against the inside of the catalytic chamber and causing a notable noise of irritation. Here is the link to the process defined last night: [ http://twinturbo.net/net/viewmsg.aspx?forum=general&msg_id=1127698 ] Solution: Drill a 1/8" pilot hole followed by a 1/2" hole into the front section of the catalytic chamber. This can be done on the ground with the car jacked up or on a lift. This hole will create a means to access the end of the pipe and fill the hole in with weld, beginning at the center of the hole and filling in from the insert until the hole has sealed. This will fix the end of the pipe to the catalytic chamber and prevent rattling. HEre are some pics: [ ashleypowers.com ] [ agpowers@bellsouth.net ] [ Zemulator Information Sheet ] [ Z1 Motorsports Website ] Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor. Albert Einstein
Follow Ups	Dr. FAB strikes again. Cheap testpipe-esque mod, Addendum A. - AshsZ 23:48:33 01/18/04 Seems like a real PITA, why not just do what Stangz88 said - T0M 00:01:57 01/19/04 Perhaps. It just depends on whether or not you like fabbing - AshsZ 00:09:47 01/19/04 no offense but is that fabbing or rigging? (n/m) - T0M 00:23:41 01/19/04 The difference probably lies more in opinion than fact... - AshsZ 00:27:03 01/19/04
Post a Followup	You cannot reply to this message because you are not logged in.