Subject	What binary counter are you using?
Posted by	xtensive on January 10, 2004 at 6:33 PM
	This message has been viewed 40 times.
In Reply To	Here are some pics of a simple consult interface. posted by DVDBURN (MD) on January 10, 2004 at 06:14 PM
Message	If that's a 4060 variant the pins are wired wrong. Pin 16 should goto VCC not pin 9, pin 8 should goto pin 12, not 13, pin 15 shouldn't go anywhere and pins 10 and 11 should goto the 10m ohm resisitor and then onto both pins of the crystal, Unless I am reading your layout wrong :-) Can't wait to see your software! Mike
Follow Ups	Here are some pics of a simple consult interface. - DVDBURN (MD) 18:14:12 01/10/04 BLAH, I was doing fine until now...now I have a headache! - Red ZX (Sr. N00b) 18:16:26 01/10/04 HA! Sorry man! (n/m) - DVDBURN (MD) 18:19:09 01/10/04 bahhh. - Halo Z 18:29:46 01/10/04 You should have seen the mpeg decoder board in the 42" - DVDBURN (MD) 18:40:15 01/10/04 I'll show you 42" ! (n/m) - Marshall 18:43:43 01/10/04 Fresh :) (n/m) - DVDBURN (MD) 18:48:59 01/10/04 does it have those 3mmx 3mm caps, and stuff like that. (n/m) - Halo Z 18:44:06 01/10/04 hehe you know it! (n/m) - DVDBURN (MD) 18:47:55 01/10/04 very nice! (n/m) - zboost 18:17:30 01/10/04 Re: Here are some pics of a simple consult interface. - northZ 18:22:32 01/10/04 What binary counter are you using? - xtensive 18:33:22 01/10/04 74hc4060. The circuit explained. - DVDBURN (MD) 20:12:40 01/10/04 Re: 74hc4060. The circuit explained. - xtensive 21:48:50 01/10/04 hey mike your registration on your website doesn't work. - Carlos Ramirez 22:14:51 01/10/04 Nice - Marshall 18:47:48 01/10/04 Looking forward to it. (n/m) - SooperZ95 19:02:42 01/10/04 Very cool, Good work (n/m) - OkcTurboZ 22:56:51 01/10/04 Very nice Gary... (n/m) - Pats300zx 06:31:48 01/11/04
Post a Followup	You cannot reply to this message because you are not logged in.